Thread: 30 degree valve job?

Tweet

yes 15 30 45 60 65 then i hand blend all to 45 in front and in back of the 45 roll the EX margin on valve . back angle the valves but first i hand lap them to see the 45 stops but this just mark s them makes it easier to work on them i set were i want the valve to hit on the 45 when i do the valve job i use stones to do this have cutter to the ruff then in and finish with stones i run the intake 45 at 060 and the ex hair bit bigger i run them on the intake up to the top of the 45 on the face of the valve and on the ex 3/4 the way up the valve face then cut just be hind it with another angle 30/35 this is how i do it. right or wrong