Which Flowmaster Exhaust Would Sound Best?

Hows everybody doing. I have a 1956 Ford F-100 with a 351Cleveland under the hood. Nothing major, pretty much stock. Small cam and thats about it. 4bbl. Anyway, lookin to get new exhaust. Going to go with flowmaster of course. Cant decide on what would sound best.

Most likely going to be 3inch exhaust..Should i go with the Hushpower mufflers or something like a 50Series? Personal opinion what would sound best. I prefer the louder the better but i also want it to be a nice deep mellow loud. If that makes sense. Or should i should just a good ol set of Cherry bombs on there?

discuss

I'd run 2 1/2" with a cross over and a pair of Cherry bombs

why 2 1/2? is there a reason behind that that you can share?

A dynomax flow chart I use, and I personally like the sound of a glass packs on sbf's, the cross over helps low end torque. :cool:

Quote:

---

Originally Posted by 2 FN LOW

why 2 1/2? is there a reason behind that that you can share?

---

bigger is not better, actully I'd say 2.25" would be best for even a mild 351. you need to keep the exhaust flowing outward, allowing the exhaust gas to expand into a large volume tube does not help, it hurts.

thanks for the info

Picking a muffler can kind of be a crap shoot, the same muffler can sound different in each application depending on such variables as pipe size, pipe routing, engine size, X or H pipe placement (if used ) and muffler location.

I just did a muffler change on my 57 Plymouth last weekend because I didn't care for the sound of the turbo mufflers I originally had installed. Personally I also like the sound of glasspacks on a lot of cars. On the Plymouth however I put on a pair of reproduction Chrysler Hemi mufflers, their actually pretty quiet but have a nice rumble under acceleration and nice sound at idle.

the 3inch big block mufflers are the only flowmasters i like and the dyno max are what i run now with a x pipe

Does it have headers? or exhaust manifolds? Whatever you have, measure the diameter of the collector and that's what size exhaust you should run. If it's exhaust manifolds it should be around 2 1/2". Keep the same size piping and you will see more HP.

it does have headers.

Quote:

---

Originally Posted by 2 FN LOW

Hows everybody doing. I have a 1956 Ford F-100 with a 351Cleveland under the hood. Nothing major, pretty much stock. Small cam and thats about it. 4bbl. Anyway, lookin to get new exhaust. Going to go with flowmaster of course. Cant decide on what would sound best.

Most likely going to be 3inch exhaust..Should i go with the Hushpower mufflers or something like a 50Series? Personal opinion what would sound best. I prefer the louder the better but i also want it to be a nice deep mellow loud. If that makes sense. Or should i should just a good ol set of Cherry bombs on there?

discuss

---

I personally would get a nice set of headers, run it through an x-pipe, and then through flowmaster 40-series mufflers. They sound great

im going to have to look into getting a new set of headers, dont know if i can swing that right now...Im a 24 year old kid, so i got a lot of other "kid" expenses...You know, the pointless BS we manage to waste our money on..Plus im tryin to pick up a new car too..Also have to get this 3spd tranny rebuilt or opt to buy the AOD, along with swapping these 4.11 gears out..

Any suggestions on where i should put the x-pipe or should i leave this for a shop to determine? Im still undecided on the mufflers..Thats going to be a tough choice..I think ill stay away from the Hushpower as i dont know much about them and them seem more for show...Granted my truck is a show truck but i also drive it as a daily vehicle during the spring/summer...So its going to be between a 40/50/etc series or a set of Cherry bombs..Theres Cherry bombs on there now but they are about 15yrs old and the exhaust is 2" and all pitted.

The x pipe should go right after the headers. And yes I would get some decent headers on there, you dont have to go really high dollar, I had some Summit cheapos for a long time and they were fine. I agree on the 2.5" pipes, a little extra back pressure helps with torque off the line. I had flowmaster 40's and were too loud in my opionion, the interior droning sound was too much on the highway. Now I have Magnaflows, much less interior noise and still sounds way cool when you punch it, a bit more expensive though. Not sure how the 50's sund but they are supposed to control interior noise better.

I would go with 40 series Flowmasters with an H pipe and 2 1/2" pipes. I've yet to hear anything sound better then my 56 Chev thats set up that way.

I Like the Flowmaster 40 series also ... Have a pair on my truck... I think the QuickFlow's have good sound too ...

yep as he said x pipe right after the headers:) I have flowmaster 40 series on my truck with a set of hooker headers, and man it sounds like heaven lol

http://www.grabthepower.com/sounds-front.asp
This is what im running on my truck great sound cruising at 60 mph . I have a 04 f150 sound is alot better in real life.

choose the 05 f150 more the sound it has the chevy's there also

None. Use Smithy's.:3dSMILE: :3dSMILE:

Mopar What are Smithy's

Smitty's are old school glass packs , available from Hot Rod supply and other's ,nice mellow tone that may be too quiet for some w full length pipes, but perfect cruising volume IMO.
for those w "droning" problems and open off the mufflers w no Tpipes - use simple turn downs, it kills that contant buzzing inside the car from every loose screw or panel.

Quote:

---

Originally Posted by 2 FN LOW

Hows everybody doing. I have a 1956 Ford F-100 with a 351Cleveland under the hood. Nothing major, pretty much stock. Small cam and thats about it. 4bbl. Anyway, lookin to get new exhaust. Going to go with flowmaster of course. Cant decide on what would sound best.

Most likely going to be 3inch exhaust..Should i go with the Hushpower mufflers or something like a 50Series? Personal opinion what would sound best. I prefer the louder the better but i also want it to be a nice deep mellow loud. If that makes sense. Or should i should just a good ol set of Cherry bombs on there?

discuss

---

I had 50 series Flowmasters on my '48 Buick with a nice 355 sbc engine. I didn't like the sound very much (loud and tinney) I put on a set of Flowmaster Hush Flows and like the deep rumble it has now. They will rap up and down and I have 2" pipes. This spring I have built a 388 stroker motor for the Buick, anxious to hear what this will sound like. Good Luck, Topless