I put anchor bolts in the floor and laid down some 3/4" thick rubber pads then scooched the compressor over the bolts and dropped four more thick rubber pads over the bolts and then put the nuts on with fender washers. Well isolated and no vibration in the shop. A single piece of 3/4" hose connects the drier to the wall plumbing. I used a lot of isolation valves and copper tubing to plumb the shop. There is an electrical box and air drop every eight feet around the shop four feet off the floor. Plus an electric and air reel in the middle. I hate extension cords and hoses. Sadly, I did not add the auto drain until afterwards so it was pretzel time when I put it in. Added auto drains to the filter units too for pure laziness.