Search:
Type: Posts; User: Flathead4d
-
11-05-2011 07:18 AM
Thread: Installing a blower on a flathead
by Flathead4d- Replies
- 160
- Views
- 44,405
Looking good. As for your clutch operation, you...
Looking good. As for your clutch operation, you might want to look into a hydraulic setup rather than a mechanical.
-
01-29-2011 07:10 AM
Thread: Installing a blower on a flathead
by Flathead4d- Replies
- 160
- Views
- 44,405
I was wondering where you went since you haven't...
I was wondering where you went since you haven't posted since last year 12/31/10. Looking forward to more updates.
-
05-22-2010 08:42 AM
Thread: Installing a blower on a flathead
by Flathead4d- Replies
- 160
- Views
- 44,405
Thanks for the update. I like the three deuces...
Thanks for the update. I like the three deuces look as compared to the 4 bbl but go with which ever fits your needs. I've run both on my non blown engine and the 4 bbl is a lot less trouble. That...
-
02-04-2010 06:17 AM
Thread: Installing a blower on a flathead
by Flathead4d- Replies
- 160
- Views
- 44,405
Good choice on the electric fan. If you can make...
Good choice on the electric fan. If you can make a shroud for the radiator to go along with it, consider that option for maximum cooling.
-
01-27-2010 07:56 PM
Thread: Installing a blower on a flathead
by Flathead4d- Replies
- 160
- Views
- 44,405
Are you going to do any porting and relieving of...
Are you going to do any porting and relieving of the block? What about the bottom end? Any straping of the mains (especially the center one). I think you will find 8:1 compression ratio a little on...
-
11-21-2009 05:05 PM
Thread: Installing a blower on a flathead
by Flathead4d- Replies
- 160
- Views
- 44,405
Great looking setup but you might want to look...
Great looking setup but you might want to look into different carbs for it. What make of blower is that?
well I decided to do another mod to gain max travel of bars past the intended travel points just for that peace of mind. 1/8 inch is to close so now I'll have 1/2" or better. I cut a 3/16" wall...
New Project