Search:
Type: Posts; User: IC2
-
10-16-2010 12:34 PM
Thread: 9" pinion yoke
by IC2- Replies
- 13
- Views
- 2,278
Just received the pinion yoke - It should work...
Just received the pinion yoke - It should work fine Thanks
Again, sorry about the MO screwup -
10-07-2010 01:27 PM
Thread: 9" pinion yoke
by IC2- Replies
- 13
- Views
- 2,278
PM your address and I'll ship off some bucks in...
PM your address and I'll ship off some bucks in whatever form you want. Probably a MO or personal check if you want to wait for it to clear, is best/easiest.
-
10-07-2010 12:14 PM
Thread: 9" pinion yoke
by IC2- Replies
- 13
- Views
- 2,278
The short version that I need is about 4" from...
The short version that I need is about 4" from end to end. I do have a long version on the diff, but right now it's installed and at this time that dimension is only a guesstimate at 5-5.5 inches
-
10-07-2010 06:36 AM
Thread: 9" pinion yoke
by IC2- Replies
- 13
- Views
- 2,278
:o:oMy screw up(now fixed) - it was supposed to...
:o:oMy screw up(now fixed) - it was supposed to say ~3.25 between caps.
-
10-06-2010 03:43 PM
Thread: 9" pinion yoke
by IC2- Replies
- 13
- Views
- 2,278
The 3.70's are the originals from the diff. Only...
The 3.70's are the originals from the diff. Only 53 years old but in close to perfect condition as far as I can tell.
-
10-06-2010 01:53 PM
Thread: 9" pinion yoke
by IC2- Replies
- 13
- Views
- 2,278
Randy - Thanks and yes, I did see those as well...
Randy - Thanks and yes, I did see those as well as Curries 'rebuilt' for $60 and Speedway's new one for $65
I was hoping someone here would have one that could be parted with that wasn't so dear. I... -
10-06-2010 09:11 AM
Thread: 9" pinion yoke
by IC2- Replies
- 13
- Views
- 2,278
9" pinion yoke
I need a reasonably priced SHORT 1310 pinion yoke for a 9" Ford differential. This is the 28 spline, with 1-1/16 u joint caps and approximately 3-1/4" wide.
well I decided to do another mod to gain max travel of bars past the intended travel points just for that peace of mind. 1/8 inch is to close so now I'll have 1/2" or better. I cut a 3/16" wall...
New Project