Search:

well with that piston. if you use a srp they 9.780 for O deck you do not deck the block till you know your CH of the new pistons. i first use the BHJ tru deck the block . then O the boring bar to...

yep thats two cams left over from two builds

your dynamic cr with the right cam will be fine with the same piston you used the first time with Alum heads and get the deck set at 0 or down in the hole no more then 0.010 the cam i would use is a...

bad hone job oil ring gap is ok if you can run on 92 pump ?or get it i been building bbc for 30 years

ok them heads are fine i used them there more of the roval ports if were not open up or over ported .what cr are you using for the new piston

what the cc runner of them rect port heads i built bbc with rect ports but were hi winders or bigger then 454s for the street low rpm big O ports work good . i think i said the cam was abit short...

walls look like there is no cross hatch look to be glazed over for a new engine . yes to start at a STD bore with new pistons is a very bad idle less bores are very nice .most all the time there...

that piston is fine but them heads are not working with that cam re hone rering re cam heads maybe to big for your build

first work on the oil if you say your burning that much oil thats not helping what breathers do you have on the valve covers ?are you sucking oil up the intake check for good seal? whats vacuum...