Thread: 1937 pontiac 4 door sedan

Tweet

Your on my same wave lenght. I posted that earlier. Beautiful vehicle there. Thanks for the good vibes.

Here's a link to a 50's Packard 4 - 2 door chop conversion.

http://ratrodsrule.com/forum/showthr...hlight=packard

Originally Posted by dmw56

Here's a link to a 50's Packard 4 - 2 door chop conversion.

http://ratrodsrule.com/forum/showthr...hlight=packard

yep seen the car here in town .on the door handles open up the door look in the door frame under the door gasket there may be a tin tab this is about were the handle would be on the out side get a big flat blade screw driver side under tab full it to you and the handle should come off

if thats how its held on alot of older GM s are

I assume it is the same as my 37 LaSalle. It should just have a square end that slides into the door hardware. I have several extra handles because somewhere along the way the ends got broken at the hole where the set screw goes in . This may be a stupid question, but did you get the set screw all the way out of the door? I only asked beause I have wrestled with those as well. Unfortunately, my best advice would be: penetrating oil, time, a little jiggling, followed by brute force.

Originally Posted by dmw56

Here's a link to a 50's Packard 4 - 2 door chop conversion.

http://ratrodsrule.com/forum/showthr...hlight=packard

for those who can't see the pics in the link here's another...


http://www.killbillet.com/showthread.php?t=21329