Thread: Wanna trade?
-
07-15-2004 12:54 PM #1
Wanna trade?
I Got a finned aluminum timing cover for an SBC but it is made fer a blower gear drive. I need one with a smaller crankshaft end opening to run a regular balancer. Bought it cause it was perty...DUH... without noticing the excessive size opening. Any one wanna trade?Justin RFFR
Isaiah 40:31
-
Advertising
- Google Adsense
- REGISTERED USERS DO NOT SEE THIS AD
-
07-15-2004 03:58 PM #2
Right behind ya Streets,
I'm gonna get a pic and measure the inner diameter of the hole at the crankshaft. Just to make sure it's exaxtly what I said it is. Hate to find out second hand I been suckin to much fumes in the garage. Buddy told me the hole was oversized fer a blower gear drive and they dont make balancers to fit it.Justin RFFR
Isaiah 40:31
-
07-26-2004 01:02 PM #3
Okalee Dokalee, The seal opening I.D. is a hair under 2.5" hard to get an accurate with the seal being malable.Last edited by Justin94117; 07-26-2004 at 01:05 PM.
Justin RFFR
Isaiah 40:31
-
07-28-2004 02:19 PM #4
Done, you can edit it offin there fore gremlins get it. Check yer junk mail, I'm sure thats were you'll find me.Justin RFFR
Isaiah 40:31
Is it going into a build, or making a trip to NM?
GM Engine de-coding