Thread: Rochester 2 GC carb spacers

Tweet

Someone does carry them Duane, I saw them and was interested because I have three of the small based ones on my Olds in the '39 Dodge. But, I can't remember who. Maybe Vintage Speed?

I'll do some digging for you.

Don

Here you go Duane:


http://www.parts123.com/parts123/yb....Z5Z5Z50000106a


It is two inch, but I think it is the only one available. BTW, there have been many reports that Vintage Speed is not the fastest shipper in the world, they run hot and cold. I buy stuff from Charlie at shows, and that way I get it in my hot little hands and know I have it.

Don

Thanks, Don.

Two inches will give me lots of clearance on the 390's distributor. And the Effes hood had plenty of carb clearance room. This should be perfect.

Denny, if I am reading the base bolt pattern correctly those are for the larger based Rochesters 2barrels used on the 389 ponchos, 327 chevys and 394 olds two barrel engines.

Don, I ordered 3 of the spacers, 3 base gaskets, and one carb gasket set ( I know my center carb needs new gaskets cause I've had it apart so many times )from Charlie. We'll see how long it takes to get them.

What did they say on the phone? Any indication of if they were in stock or anything?


Don

Oops, used the internet to order. Didn't think to call and ask if they were in stock. Oh, well. They get here when they get here I guess. I get a little leery about ordering on the phone cause people have a hard time understanding my electronic voice, especially when I am spelling my last name. Hehehe