Thread: 350 SBC for sale

Tweet

I have a rebuilt 350, bored 0.040" over with 4 bolt mains, flat top pistons, Edelbrock Performer RPM cam and intake, double hump "fuelie" heads with oversized valves (2.02/1.60), and high lift springs. It's not complete, missing the carb, distributor, balancer pulley and starter. It's never been run, it has sat a little while and there's a little surface rust on the exterior of the block and heads, but the crank still turns very easily. A little elbow grease, and it'll be as good as new. Edelbrock technical support told me that I would be making over 400 hp with this setup.

I;ve got over $2000 in it, but I'll take $1000 (negotiable) for it, it's located in Anniston, Alabama, about halfway between Atlanta and Birmingham. Let me know if you're interested. Thanks!