350 SBC for sale

I have a rebuilt 350, bored 0.040" over with 4 bolt mains, flat top pistons, Edelbrock Performer RPM cam and intake, double hump "fuelie" heads with oversized valves (2.02/1.60), and high lift springs. It's not complete, missing the carb, distributor, balancer pulley and starter. It's never been run, it has sat a little while and there's a little surface rust on the exterior of the block and heads, but the crank still turns very easily. A little elbow grease, and it'll be as good as new. Edelbrock technical support told me that I would be making over 400 hp with this setup.

I;ve got over $2000 in it, but I'll take $1000 (negotiable) for it, it's located in Anniston, Alabama, about halfway between Atlanta and Birmingham. Let me know if you're interested. Thanks!

Do you have any documentation regarding the work done and would there be like a 30 day or 3000 mile warrantry?

Pics would be nice also ;) if you can provide the above I can bring you the money this weekend.

Is this still available?

Have you sold this motor yet? :confused: