Thread: Need advice priming a fiberglass body

Tweet

Originally Posted by Itoldyouso

BTW Bob, I bought some pantyhose last night, and have to admit they really do pull the slivvers out. I could see the white stuff on them after using them, and I had no itch last night. Thanks. I was on the fence between regular and control top.............................

Don

I can just imagine what's going through the minds of some who are reading that out of context!

Oh, BTW, the breathable crotch......................................................oh never mind!!!

Yeah, now that I reread it............


Don

Originally Posted by Itoldyouso

Yeah, now that I reread it............


Don

It takes all kinds to make up the world, so I sure never would have made a comment - but Bob.....

Before you even use the wax and grease remover - wash the heck out of it with some dish detergent like Dawn to get the first greasy layers off then go over it a minimum of two times with the wax and grease remover - I will do 3 or 4 but I tend to do a bit of overkill.

And to hijack the thread a bit but still on the same general subject. I just used some high fill polyester primer on my doors as they are "Brookville poor" with a bunch of low spots. It is very hot here today over 90 and the @#$% stuff partially set up in my gun. I've just spent about 45 minutes cleaning it out - what a mess. It was supposed to have a 45 to 60 minute pot life - wrong - today, maybe 10-15. And I used up most of my cleaning thinner so off to the paint store.