Hard to beat the cubes...Getting a .030 over 360 to a 426 is impressive!
No replacement for cubic displacement they always say

At any rate 2500 bucks is not a bad deal...Then you need some oval port aluminum W2 racing heads a Air Gap intake, Demon carb...It gets expensive quick....

But for about $10,000 you will definately have a motor that will run with anything out there....600 hp without nitrous easy...In a lightweight small block that is amazing....Bang for the buck it is hard to beat...

...Mind you it is tough to get a car that can handle that kind of power down the track or street without mini tubs, tying in the frame rails and a roll cage...

putting too much motor in a Car means mini tubs and a roll cage at the local track...Once you go faster than 11.5....And with a small block Stroker kit you can top that in your sleep.