No, just regular epoxy. I have used weld thru before and hated it. Caught on fire, couldn't get decent welds and it still requires finishing after welding anyway.
I use the epoxy, clean the weld spots before welding and touch stuff up afterwards.
No real benefit to "weld thru" primer that I have seen and I will not use it again.


With that said I did get a lot of work done this weekend.

I dug out the 3 in 1 Saturday morning and got the two channels bent up.


For a cheap HF bender this thing does a good job. I've been using it for 8 years and have not been disappointed with it...

Getting them bent the long way was the hard part. After some offhand cutting on the bandsaw I could get the them bent into the shape needed for the cowl.



There isn't much I can do to get these fit to the cowl until I get the patch panels welded in.
Passenger side.
[imghttps://media.fotki.com/2v2HofE2Fx9EDKg.jpg][/img]
Drivers side.

With the channel covers held in place. These should work!


Thanks for watching.
Mark