Thread: Streetwerkz 30 sedan build

Tweet

not much done today, as I had a guest drop off a project that took a while to go over

needed to add some inner structure support, so I made this out of 1/4" X 2" bar stock, then gusseted the ends.
hard to believe this little bracket took about 2 hours to make

I had to first measure the radius of the gas tank so I could match it, and then bend the ends down, and add gussets at the ends for strength.

befor, the area where the bolts are

cut the bar stock, measured the radius, rolled it to form, then bent on the ends, and matched hole locations

Added gussets on the ends, and welded into place

So now I have more over all strength, and a lip to werk from for the new dash