37 Ford build--IE: old Header issues thread /37 Ford/5.0/GT40P heads

[IC2]

'mornin' folks. Randy and Mike, glad to see you folks up and around!!

I'm here every day but don't post quite as much as I used to, but it's still fun. I've had my car out a couple of times, but not as much as I had hoped. Too many other things, mostly house related, going on. I did get some wind wing brackets so now have to make up some templates for the glass. The template supplied makes them way too big.

Randy - slow progress is way better then none

And as far as "faults" - I found a couple that I hadn't seen before when I did good polish, but neither is a big deal. Mike, if you have a run or so, a single edge razor blade (careful ! ) will work as a scraper. Just knock off the sharp corners. There are tiny body files especially made for them too, but IMO, don't work any better then a $2 for ten pack of blades.

Gotta get back to supervising the new roof going on above me ($$$$$)

[34_40]

'mornin' folks. Randy and Mike, glad to see you folks up and around!!

And as far as "faults" - I found a couple that I hadn't seen before when I did good polish, but neither is a big deal. Mike, if you have a run or so, a single edge razor blade (careful ! ) will work as a scraper. Just knock off the sharp corners. There are tiny body files especially made for them too, but IMO, don't work any better then a $2 for ten pack of blades.

Gotta get back to supervising the new roof going on above me ($$$$$)

Hi Dave and thanks for the razor tip. New Roof = CHA CHING!!