Thread: Project $ 3 K Is Underway

Tweet

The next thing I did was build a mount to afix the master cylinder to the frame. You can use just a flat plate to do this, and gusset it, but since this car sits so low I want some protection for the master cylinder in case the car bottoms out or hits something in the road. I used a piece of large angle iron, and after cutting it I drilled the proper pattern into the front edge to accept the Ford Mustang master cylinder I bought last week. I also made up a 3rd wall out of 1/4 inch flat stock, so when the whole thing is welded to the frame it should not only be strong, but act as a skidplate to protect the master cylinder. I'd hate to wipe out the master cylinder on a speed bump or pothole.


The last pictures show the pedal and master cylinder mount, and their relationship to one another. I still have some work to do on them, but this should give you some idea of what I am shooting for. That flat plate you see on the side of the master cylinder will be welded completely to the frame and to the angle iron mount, so it should never move.

Thanks for looking,


Don