Thread: Alumicraft grille

Tweet

Does this "new" grill design allow you to remove one side of the nose to access that side of the engine without remove the other side of the nose and grill? That would be a major improvement.

Originally Posted by hammer-time

Does this "new" grill design allow you to remove one side of the nose to access that side of the engine without remove the other side of the nose and grill? That would be a major improvement.

That would actually be impossible since the hood side must be moved forward and up to remove it. The hood side laps under the main body, right below the A pillar, at the belt line by several inches and must be moved forward by that amount. The fenders also bolt to the hood sides, so they would need to be removed first.

I have my hood sides separated, which does allow me to install or remove the grille for access to the A/C condenser and hoses, without removing anything else. The stock Oze hood sides are one-piece. That requires the grille to be mounted to the nose section, before it's installed on the car. Removing the grille then requires the hood to be removed first and then the fenders and hood sides. To me, it's a major design flaw that really fouls up servicing.

I can't think of much engine service that can't be done with hood sides in place. The fenders are what really get in the way of getting up close to the engine compartment.

The grille design is really unchanged, other than adding the aluminum top plate. All Dan did was drill four countersunk holes for some #10 flat head bolts, into the top fin. The top plate slides under the top fin. The top plate has four matching 10-24 threaded holes so there are no nuts needed. The top plate is installed after the grille has been attached to the hood sides.

The top plate could also be made to sit flush with the top fin, but that requires more work, like welding some mounting tabs to the underside of the top fin. Eventually, I want a custom top plate that is flush and has a 90 degree bend at the back, to cover the gap between the top plate and the top of the radiator. I have some ideas on how to do this with .06" aluminum that I can bend, without too much trouble. The top plate I have can serve as the mounting surface. Adding some .06 aluminum as a spacer under the new top plate will space it up flush with the top fin. That project will have to wait until a whole lot of other things are done.