How about a home built or cheap tool modification thread?

[34_40]

And here the write-up is.

Hi.

Part and instruction, it is real simple, he will want a purchase a 10" pulley AKA DRIVEN PULLEY

The saw as a wood saw has a belt that goes from the top pulley or DRIVEN PULLEY to the motor pulley.

Starting remove the DRIVEN PULLEY, this pulley will be replace with a 10' pulley

The MIDDLE PULLY is the JET part, seen below. ( see manual cover)

You can see the Jet part mounted and alined. 3 holes were drilled. Long bolts and nut used to hold it in place & aline the 10in Driven pulley and middle pulley (Jet part) as seen.

Part number on the cover of the manual.

Finished install

Hope this helps, ask questions if you like, it is really a simple deal. The pulley set up seen has never change, lowest speed.

Cuts header tubing, angle, round bar, square bar, flat steel & sheet metal: 1/16 too 1/2, even a 4" think aluminum block took a while to get thru that chunk
Saw in use close to 20 years, buy good blades they last

[34_40]

And here are the remaining pictures that Pepi provided.

Hope the info helps, it was a good question and I want to do something similar so me helping you was self serving.

[RestoRod]

Thanks 34-40. That is exactly the information I need. I will bookmark this and compare it with my saw to see if it is compatible. Thank Pepi for me.
Hopefully this may be helpful to some other members as well.