Yes, nickle would work. I tried welding on my pumpkin to see if it was cast or steel, It laid a nice looking bead and I broke the bracket off with a small hammer. That was using a wire welder though.
Printable View
Can you weld an iron LSx Block?
Depends on where it's cracked and how bad. I welded a crack in the starter mount on a SBC. It was a good engine that I didn't want to replace. Again, I tig welded it with nickel.
If it was in a water or oil area, I would most likely trash it.
This was on the wall adjacent to the motor mount
I wouldn't trust it. That's a water jacket as well as a high stress area.
I've pinned a few cracked blocks with good results.
Slow week this week as the shop had some other priorities. Work on prep continues. Next week they are moving it to a fiberglassing guy that will align the gaps, fill the holes, and close the openings.
Attachment 69161Attachment 69162Attachment 69163
Have you considered contouring the front edge of those back fenders any, like coming out from the body and initiating a smooth curve with a large radius? That flat bottom and sharp corner seems kind of harsh, to my eye, but beauty is in the eye of the beholder. I'd probably do the same in back, but then again I'm not a big fan of fenders on a highboy so my opinion doesn't count for much.
I had the same thought as to the outer edge. With the roundness of the body versus the fenders edge along the bottom being "sharp"..
Some small curve would be a help to blend it together.
It goes to another fiberglass guy next week. We have plans to have a rolled lip on it and to smooth the sharp edges off
Attachment 69165Attachment 69166Attachment 69164
Can he take a couple of inches out of the total width? Or maybe you're planning to fill the fenders with wider rear wheels & tires? Same for the fronts, to my eye I'd split them and take out enough to just cover the tread, but again that's just what pleases my eye, which matters not at all.
I have no real plans on widening the tires. The front fenders have already been narrowed nearly two inches. their role is to prevent damage to the paint job that eventually is coming. We are going to bob the rears more to soften the sharp corners and accentuate the tires. I have been told these fenders are actually more oriented towards the 32 Fords
Attachment 69170Attachment 69171Attachment 69172Kind of intimidating when the car is sitting next to an all steel body 1934 Chevy, full fenders small block. Kory has some awesome projects. This car has been in his family for decades.
We took the car out to a fiberglass shop today. They are going to finalize all the gaps, repair the holes and so forth.
Attachment 69189Attachment 69190Attachment 69191