The Chevy Van that my front axle come off, had the tie rod assembly behind the axle. It needs to be in front of the axle on the T-Bucket. I unbolted the steering arms from the spindles, and swapped them from side to side. The only problem with doing this is that the part of the steering arm that connects to the drag link would now be on the the passenger side instead of on the drivers side where it belongs .
So I cut off that part of the steering arm, and will have to fab a new one for the drivers side spindle. I am going to use the stock Chevy tie rod assembly. I replaced one tie rod end that was rusted up, I will reuse the other one.






Steering arm1 (640x480).jpgSteering Arm2 (640x480).jpgSteering Arm3 (640x480).jpgSteering Arm4 (640x480).jpg