Started fabricating the upper strut mounts

[IMG]20170112_162017_resized by Ben Modified, on Flickr[/IMG]

Sourcing parts for a short driveshaft with a slip joint to accommodate the rubber mounted engine

[IMG]20170112_161727_resized by Ben Modified, on Flickr[/IMG]

The male and female yokes fit perfectly but unfortunately are never quite in-phase. Today I machined an alignment collar so that I can cut, rotate and weld the female yoke. Currently it is out of phase by 9 degrees which apparently will cause noise and vibration.

[IMG]20170112_161708_resized by Ben Modified, on Flickr[/IMG]

http://www.BenModified.com