Thread: 1940 Ford Pickup

Tweet

Originally Posted by Navy7797

1st attempt at body filler and block sanding. Still needs more sanding and filler but its a start.

What filler are you using? When you need to cover a large area, I'd try U-pol flyweight. It sands easier than anything I've ever used. U-pol gold glaze is great too, and they can be mixed. If you're getting close enough to "straight", Evercoat superbuild or fiberfill sprayable filler/primer sand easily. With any luck you can sand it down until the first high area shows and quit. Then you're ready for the final primer ( epoxy, urethane, or evercoat slick sand). I've been using it on many of my large areas, like trunk lid and door sides.

U-Pol UP0745 Flyweight Gold Lightweight Body Filler

http://www.autobodytoolmart.com/u-po...0-p-17024.aspx

Evercoat Super Build 4:1

http://www.autobodytoolmart.com/ever...9-p-11007.aspx

Originally Posted by daveS53

What filler are you using? When you need to cover a large area, I'd try U-pol flyweight. It sands easier than anything I've ever used. U-pol gold glaze is great too, and they can be mixed. If you're getting close enough to "straight", Evercoat superbuild or fiberfill sprayable filler/primer sand easily. With any luck you can sand it down until the first high area shows and quit. Then you're ready for the final primer ( epoxy, urethane, or evercoat slick sand). I've been using it on many of my large areas, like trunk lid and door sides.

U-Pol UP0745 Flyweight Gold Lightweight Body Filler

U-Pol Liquid Gold Pourable Glazing Putty

Evercoat Super Build 4:1

Evercoat 709 Slick Sand Polyester Primer Surfacer - Gray

Using 3m platinum body filler.