Thread: 51 Moredoor

Tweet

Thanks, I felt much better today and was able to get a lot more done. I finished the underhood wiring and installed the cooling fan and bled the brakes. For some reason one of the back calipers is not getting fluid; I'll have to figure that out. Even still, it's got a good solid pedal. The stock wheels wouldnt fit over the disc brakes so I pulled a set of steel wheels off of a Crown Vic last time I was at the boneyard. I've got a set of full wheel Plymouth hubcaps, i'll just use those and get some fresh rubber. I didnt like the rearward angle on the shifter so I cut it and welded it back together to be more upright. Im real close to a road test; just need to get a driveshaft made and put an exhaust system together. A couple of bummer notes; my cool old tach doesnt work and Im having a fuel gauge issue. I've got a new VDO 0-90 ohm gauge and a 0-90 ohm sending unit. I dumped about 3 or 4 gallons of gas in the tank and I read 34 ohms on my meter going from the sending unit to ground. I checked it up at the gauge and I read the same from the sensor terminal to ground. But when I turn the ignition on, the gauge goes past full. Any ideas???