Thread: Ford 5.0L help
Threaded View
-
06-23-2008 11:38 AM #1
Ford 5.0L help
I found this engine from a guy I know and he is pretty good guy. He's willing to give me this for $700 plus some parts that he could use that I don't need. I want to try and run my Edelbrock 600 carb on it and I'll need an intake. It's going on my '31 Model A Streetrod that I've been working on(before it was a '27 T Sedan ). I'm looking for opinions on what I could do with it without spending too much more money, and what tranny I should look for. I'll tie it into a Chevy 12 bolt rear end cause I already have the brackets welded on. Just don't want to have to buy a blower. Maybe a new cam though.
For sale ; 5.0 L complete engine spec'd for a blower
The engine has about 950 km on it.
Aluminum Trick Flow High Port heads, DSS forged 1.600/4.030/ - 13 cc low compression inline pro series pistons. Custom grind cam from flowtech induction ( part # SC1934-HR112 )
lift 1.6 ratio , intake .5632", exhaust .5664" , lobe seperation 112 degrees. , Aluminum roller rockers 1.6 ratio, powerbond balancer, Ford Explorer upper and lower intake.
I'll try to get more info.
Thanks,
Sean.
My wife told me the kitten needs to be chipped. I had only a 9 iron but I still got it over the shed.
the Official CHR joke page duel