Thread: Help identifing a motor

Tweet

Can't say for sure from your pic, but it looks too narrow to be a 351. They are a couple of inches wider than the other Windsors. Looks like a factory 4V intake on there, so it might have some more of the "goodies"!
The E3 manifold was first cast in 1983, so it could be an '83 engine.

Originally Posted by R Pope

Can't say for sure from your pic, but it looks too narrow to be a 351. They are a couple of inches wider than the other Windsors. Looks like a factory 4V intake on there, so it might have some more of the "goodies"!
The E3 manifold was first cast in 1983, so it could be an '83 engine.

Thanks R Pope,

i was just told about the width last night by somebody, they were saying the 351 would be around 9 inches across the top of the manifold from man. bolt to man. bolt, and the 302 were around 7 inches measured the same way, is this correct or does anybody have a more accurate dimension??


i wish the motor was at my house...but its not, so i'll pass this info off to my buddy, thanks,

Jason are you out there, did you measure it or take a valve cover off, post up, what kind of motor is it....its starting to drive me crazy