Thread: PCV in Valve Cover...
-
07-15-2007 06:07 PM #1
PCV in Valve Cover...
I searched for this, but everything was for SBC... I have a 5.0 HO that is coming out of a '90 Lincoln Marck VII and going into my '31 Model A. What all do I need to do to get the PCV in the valve cover. I like the looks of the valve covers on this 5.0 and would like to run them on my fenderless/open hood Model A.
I am pretty sure that I could drill the correct size hole for the grommet and get the PCV valve in there, but is there anything else that needs to be done or is this really not feasible??
Thanks in advance...StillKruzn
-
Advertising
- Google Adsense
- REGISTERED USERS DO NOT SEE THIS AD
-
07-15-2007 06:32 PM #2
That is exactly what I needed... Thanks!StillKruzn
Here is a diagram to install a GM HEI Module. This is the route I think I'm leaning towards.
Chrysler Ignition Setup Questions