Originally Posted by pat mccarthy
hmmmmmmmmmmm fords are no way much better than chevys have seen alot of omc fords 460 in the machine shop and the head bolt pattern ? the chevy hase a much better head bolt pattern then the fords and on the deck there is alot of 427 tall decks out there if you look around ? i guess not ?to busy looking at ford parts ? 526 cid to541with out to much work yes not 572 . and on the rods a stock 460 rod s are not that hot.have you look at the chevy 3/8 truck rod? but lets forget all that. they do have a big bore that is about it .the mains are to big and the rods ? so i do not think they are that great over the big block chevy? where? but hey i am a chevy guy and you i see are a ford guy? but last time i check mercruiser was doing good with the poor big block chevy and last time i did check sterling engines .was doing very good with the big block chevys?off shore ????the chevy has adjustable rocker studs your ford dose not . and the big block chevy block stock can take alot of hp? how much hp do you want to run down a stock block ?over 600+ hp all day long. how much on the ford before the head gaskets go south ? and it must bug you ford guys to buy them 6.700 -6.800 h beam rods cut for the big block chevy rod bearings and to cut your crank for chevy rods?for the lifter size ? i have runned some big cams big in the chevy .800 lift and did not hit any thing ? big lifters more valve train mass to hold down . if i piss any one off? i did just want to say this. and i do know it is a ford post. but hey i did not say why chevys big blocks are better than big block fords and not think i would not get some heat ?from a post like that . a stock chevy block is very good and no way is the ford stock block better ?tell me were i like to know? do you know much about chevys? and i can get 511 out of a short deck stock block and 541 a 4.1/2 crank will drop in with very little work in a tall deck 427 block. and the milodon pan that is $175 will work just fine out of the box. but i would use the #31195 for a boat.and you could get more out of a stock tall deck block .and this block hase a 4 bolt main and with steel caps over 900hp you may want to look at the chevy a bit more ?????