What kinda hp??

k... this is what i have so far. I have a 1977 350 chevy 4 bolt main crane cam and lifters, holly strip dominator intake, carter 750 cfm carb, hedman ceramic headers, gear drive, mallory HEI and wires and chevy 333882 heads with 202 valves and 372 gears with a borg warner T5 5 speed. I have all the components just havent intalled them yet.. will these componts work together well..any suggestions...What kinda hp approx???...I drive this car to shows and the strip.








Cam Specs

http://dab7.cranecams.com/SpecCard/D....asp?PN=110551

Acually, if all of them are specified for this engine, It would all seem to be compatabe, except maybe for the intake and carb. Ive seen a few holldey intakes not like other carbs, but that can be cured with a spacer. Now, for my next question, who bought this stuff? They seemed to have taste. I would have swapped a few things over, but its a nice little ensemble you have there. If you do well, and the engine isnt fried, 300 is possible.

will that cam work alright on the street....

For your cam it depends on your lift and dururation and grind, just check the specs and post them, i can tell you if its going to idle rough or idle at all or idle smooth or whatever idle there is possible.Your carb will bolt right to the intake, holly and carter are virtually the same carb and they are interchangeble between the two

the cam specs are on my first link

I dont see any cam specs anywhere ?:HMMM:

Holy crap, your right. What would happen f he shaved .20 off the heads, that would put him in the 65-60cc range-right? and that should be fairly cheap.

Thanx for the advice guys...i guess ial have to look for other heads.. i really want vortecs heads up in ontario canada there hard to find.all the ones i've found will only be sold with the motor and on ebay and shipping would kill me from the states..i do have a set of rebuilt 305 heads laying around but i was told to stay away from them....they have small cc but i herd they dont breethe well and they will only go to 5000 RPM has anyone used them...

so 305 heads would be a bad idea??

Nah, they should be fine! :LOL: All you have to do is hone them out for bigger valves, bore out the bolt holes, and pray! A lot. The 305 was yet another emissions engine. Why did the US have to make so many d@mn emissions laws? Couldnt an unleaded 350 with cats be enough? nooo, got to be cleaner.....

In reallity I don't think the 305 had any less pollution than a 350. I have heard of using 305 heads on a 350 in dirt racing applications but never a street or drag application.

are 305 headsoon a 350 bad? YOU bet they are!