Thread: Fuel issue? Carb issue?
Results 1 to 13 of 13
Threaded View
-
08-08-2009 06:49 AM #13
i had a 1986 mity max pu made by mitsubsh*ti the fuel tank was mild steel,i would be running down the road and it would die.i bought this truck new.instead of plastic tanks they used bad steel.it became so common that i bought a case of fram fuel filters and keep then in my little storage pin in the truck. i got real good at changing fuel filters on this truck i could do it in under a minute.the filters were next to the fuel tank under the bed. so in you case i would pull the tank have it flushed and sealed(get a sealer that will work with ethnol.) run new stainless fuel lines to the engine(i;m currently doing this to my studebaker lark that i'm building).this mixed fuel is not going to go away.and carry a few extra fuel filters.
carter was the parent company of the afb they were sold to weber and edelbrock either buys there carbs.from weber or bought the carter co. but i have a lot of carters that i bought up during the 60-90's.Last edited by hotrodstude; 08-08-2009 at 06:52 AM.
That is terrible, sad to hear about him.
RIP Mike Frade, aka 34_40