as I read in my ignition system book I did some tests on coil and wire resistance. The book says coil primary side resistance should be less then 1 ohm, secondary side could be over 1000 ohms.
My primary side is about .8 or .9 ohms and the secondary side is over 4000 ohms. It is an msd blaster 2, I using an MSD 6AL box with it.

I measured the resistance of my coil to cap wire, which is about a foot long, and it measured 1300 ohms. I measured another arbitrary plug wire just to get a reference, (#2 cylinder wire), and it was about 400 ohms.

I haven't gotten very far in the book yet but I don't think my coil should have that much secondary resistance, and I also don't think the coil wire should have that much either.