Hybrid View
-
06-11-2003 08:47 PM #1
how to put fiberglass scoop on metal hood
i'm putting a harwood outlaw scoop on my 79 Trans Am hood what is best way to bond it to the hood and fix the seams and what to use to bond it with thanks
-
09-03-2003 12:24 PM #2
in general, sand the hood to clean metal and get some fibreglas resin and just glue the sucker on....fiberglas will adhere to clean metal just fine. For more insurance, you could also rivet it on if you want, and i would tend to do it that way. then you can glas over the joint and sand down like any body work repair.Chris
Only the dead fish go with the flow.
Well I've sure gotten old too so don't worry about it! I've had two bypass surgeries, new knees, fought prostate, cancer and diabetes. I'm half blind, can't hear anything quieter than a jet engine,...
the Official CHR joke page duel