'56 Chevy Wagon. 350 sbc, starts and runs fine. AAW wiring harness. Previous installer with ZERO talent for doing wiring...
Started out for a car show this morning. Got about 10 miles and the car shuts off. Dead, nothing. No fuel pump, nothing.
Called AAA (again) and had it roll backed home. Push it in the garage and, just for grins, I hit the key... FIRES RIGHT UP!
So, I know I have a bad connection some where that is getting hot... Tomorrow I will be getting under the car to check the solenoid and ground connections. Any suggestions? I am to the point where I am going to rebuild the entire start and charging harnesses.
If you follow my wagon thread you know this is what I found last week while chasing gremlins.

Cutting it apart found this.

So this is what I am dealing with. I figure the only way to make this right is to redo everything.
Mark