well yep your right and may be guilty. if guys had the money they would be using all USA parts in there engines i been using there rods and cranks for over 10 years knowing were to use the parts and were not to helps BUT i seen many a scat crank under a 800+ engine one over 5 years . but were they can not make stuff is . timming cover.oil pans . valve retainers. valve locks. rocker studs. rocker arms. pushrod gulde plates . intake manifolds . any studs or bolts. blocks. or heads . i been down the road on some of the stuff on the list . some knowing it was china at the time and some not buy a parts house name part finding out after. some it can be made to fit and last and some is just plane junk there steel rods and crank s seem ok there casting of alum is abit iffy