Thread: 327 engine itake warped?
Results 1 to 15 of 19
LinkBack URL
About LinkBacksThreaded View
-
11-21-2011 03:29 PM #5
CHR Member/Contributor
- Join Date
- Apr 2005
- Location
- bay city
- Posts
- 10,546
check the china walls /cross gaskets if block deck/heads have been cut alot the intake will bottom out on the block before the intake gaskets seal on the heads if so bottom of intake needs to be cut gaskets are very thick .005 is not stopping the intake from sealing 020 yes intake just maybe over cut for milled heads /block and need a 060 gasket so intake is just to small think of the intake is a cork stopper and is now just to smallLast edited by pat mccarthy; 11-21-2011 at 03:32 PM.
Irish Diplomacy ..the ability to tell someone to go to Hell ,,So that they will look forward to to the trip
Reply With Quote
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
This site is up more often lately, but very little traffic.
Dead!