Thread: 302 cyl head print (needed!)

Tweet

OK----put 2 bplts--3/8 with sesctoion of untreaded shank into the two bolt holes---take a starret ruler ( 1/2 wide) put across the two bolt shanks, measure to top of port----measure to bottom of port---play with the constant values in this game ----3/8, .375, 1/2, .500, .1875, .6875, .875----a little addition, a little subtration, a little of this, that, etc----if you can't fiqure out the diminsions--------

Originally Posted by jerry clayton

OK----put 2 bplts--3/8 with sesctoion of untreaded shank into the two bolt holes---take a starret ruler ( 1/2 wide) put across the two bolt shanks, measure to top of port----measure to bottom of port---play with the constant values in this game ----3/8, .375, 1/2, .500, .1875, .6875, .875----a little addition, a little subtration, a little of this, that, etc----if you can't fiqure out the diminsions--------

Yep, you can scale it either graphically or by Jerry's method, but the point is the kid is asking for a Ford drawing that shows that dimension, thinking that if the dimension shown on some design drawing is used the world is in balance. Not saying it cannot be figured out, just that it cannot be calculated. Look back at post #23 of this thread and you and I are on the same page, Jerry. He did not like it then, either