Thread: '00 mustang oil pan\rod bearing
-
10-21-2007 07:02 PM #1
'00 mustang oil pan\rod bearing
A friend of mine asked me if it was possible to roll Rod bearings into his 4.6l.
I know there is a host of other many problems to go along with doing this, crank scoring, rod issues ect. He would just like to be able to drive it for a month or so so he may save up to have it done properly. I'm not sure if I want to attemp it, does anyone know if it is possible to roll bearings in and how big of a pain it is to peel the oil pan off?I've got the itch to lay some rubber down!!! ~Thanks grampa! its been 10 years worth of work, I just wish you could see it~
-
Advertising
- Google Adsense
- REGISTERED USERS DO NOT SEE THIS AD
-
10-21-2007 11:03 PM #2
exactly...... getting the pan off on that car is a PITA when its still in the vehicle..... but it is doable.... just be careful doing it.... you'll probably have the engine lifted a little and the car jacked up.... thats a good situation for a car falling on youjust because your car is faster, doesn't mean i cant outdrive you... give me a curvy mountain road and i'll beat you any day
well I decided to do another mod to gain max travel of bars past the intended travel points just for that peace of mind. 1/8 inch is to close so now I'll have 1/2" or better. I cut a 3/16" wall...
New Project