Thread: piston rings whats yer favorite!?

Tweet

wells i ordered hastings mahle's so i hope they work

Originally Posted by gassersrule_196

wells i ordered hastings mahle's so i hope they work

Hastings and Mahle are two different companies.
Do you mean moly rings??

ahh yes you say tomayto i say tomatoe i say mahle you say moly? yes moly. i really should pay more attention course most of my posts are at 1 am !

Originally Posted by gassersrule_196

ahh yes you say tomayto i say tomatoe i say mahle you say moly? yes moly. i really should pay more attention course most of my posts are at 1 am !

Make sure you tell your machine shop that you are going to run moly rings so they can put the right finish hone on your block.

i use a plateau brush on miss moly

i have two one just a brush uf-450 $55.79 at goodson and one that runs on a sunnen AN hone head goodson is were i got mine . no i do not have a used ones. but if i see one i will let you know. about 5 passes down the hole and your good . i go from AN 301 and hop up to the N37-j85 about the same passes with them to . and i go to the brush

Originally Posted by DennyW

Ok, thanks Pat. I found one for 35.

yes the smaller ones are less that was for a 4.000 -4.500 but have used it many times on the 4.600 bores

thats not bad deal if not a screw up on there part ?