This thread isn't to discuss whether a single four barrel is better then multiple carbs of any kind or how hard the set-up is to tune. I'm thinking about going this route in the future to get the look I want on my truck. Probably three two barrels but I want to check out the six singles too. I noticed that a six two barrel manifold is also available but i think that would be way too much. If you've noticed on my previous posts I run a tight budget so buying a full set ready to go is a little out of the question.

I'm thinking though I could defintely keep the price down if I obtain my pieces seperatly at swap meets or online over the next year, manifolds by themselves tend to go for 75-150 and carbs individually 10-50. However, this will absolutley not work without the right info. I need a good reference for carb casting numbers, rebuilding, parts availabilty, and converting to a multiple carb set-up. Do you guys know of any good sources for this info or a book I can get ahold of with this info. I can probably figure out some of it on my own but I definitly need a good source for casting numbers and specs so I can purchase the right carbs depending on what I want to do. Thanks as always!