Results 1 to 7 of 7
LinkBack URL
About LinkBacksThreaded View
-
01-23-2007 07:42 PM #7
CHR Member/Contributor
- Join Date
- Apr 2005
- Location
- bay city
- Posts
- 10,546
if you just use a mic and set your bore gauge off the mic you used on the crank is works very good and i do it all the time and i read and set them to .0002 any more than that i do some things .and will not get in to all the things i will or have done but oil clearances is a very big deal with me and can tell you if you have a low side crank + polished and big rod housing bores on the rods with STD mich bearings it will be loose been thru this may timesLast edited by pat mccarthy; 01-23-2007 at 08:34 PM.
Reply With Quote
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
I'm happy to see it back up, sure hope it lasts.
Back online