let me refrase that. Im not trying to be smart, i appreciate youre advise techinspector,and youre knowladge. i should have known better when i ordered a 12 inch converter
i spoke with a genlemen from lunati who is very knolageable it might have been this harold that every one talks about he spoke with me for about a half hour on how to get this cam to work for me for my intended use, being that i was a little low on compression we had to figure a way to increase cylinder pressure ,by overlap. the cam runs real strong from 25 to 6000 with 15 inches vacuum at 750 , the problem im having is trying to get it to idle in gear at a low rpm and to much advance at half throttle, i will figure it out , and i realize that a small cube motor is going to make the cam sound bigger and act that way, if i turn the idle to 1100 and in gear at 750 i have no problem but you cant hear the cam no more, and as far as the pinging ... ill disconect the vacuum from the dist. all together and see what happens,ill also have to replace the springs and weights for my advance, the carb is adjusted for max idle capability by using a vac gauge, i was just wondering if any one used this cam and were they idled , i still beleive i was misled by jegs saying the converter would work