I have a back half clip question. In high school I saved up and purchased a 4-link suspension and a welded rear frame for my 56 Chevy from chassisworks. I installed it by reading the directions supplied by chassisworks, that was about 7 years ago. I recently started to work on my car again. I went bach and rechecked all of my measurements All of them are perfect except for one. The 4 link crossmember is off a little less than a quarter to one side. The brackets were allready welded by chasissworks so one bracket is slightly closer to the inside of the stock frame and the other is slightly further away. How much will this affect my car? It will mainly be a prostreet car. Should I scrap the frame?