Thanks for the replys guys! The pic did work. I didn't think it would show up. The frame did come welded together as pro70z28 describes The picture is what basically what I recieved. One pair of arrows is pointing to where the frame was cut to fit in between the original frame rails. Thats where the math is off this shifts the front part of the frame over almost a quarter of an inch. The frame rails which extend to the back weld to the end frame piece which supports the bumper. The end frame piece was bolted to the car so I know it aligned. I also measured the end frame rails from right to left
they are welded in the correct places. Will this greatly affect my car? What do you guys think I should do? I do have spare pieces of frame left which were cut off. If it does'nt affect my car greatly then I don't mind leaving it but, if it will then I'll fix it. I have a 210 Lincoln wire feed welder so anythings possible.