Thread: blown slantsix

Tweet

pat do you know there price for the tool? rottler is the name of the boring machine that it well fit and is it possible to do the head with the same attachment?

Originally Posted by terrylittlejohn

pat do you know there price for the tool? rottler is the name of the boring machine that it well fit and is it possible to do the head with the same attachment?

look online rottler is the name of the boring bar but there is other makers you need to find what your machine shop has for a boring bar they all hold the tool differently as here is were to look www.goodson.com

thanks pat seems the holding tool is anywere from $84 to $119, i will have to contact the local machine shop here and put that idea to him

hello all. I was just reading the posts and this caught my eye, I talked to a guy some time back and he stated that he had a like problem. he then told me that he took a small punch and hammer and dimpled the block and the head so that the gasket would not move under boost, I never seen the engine but he swore that it did the trick, wonder how long it lasted? maybe someone else has more info. GOOD LUCK dave

do you know if he was using a steel or composite head gasket?

I may have an economical fix for you. I ran into these guys several years ago when researching copper head gaskets. They make a very thin compression ring that is affixed to the head gasket and does the same job as an o-ring. Click around on this site and read everything, then call them and discuss making a gasket for your application......
http://www.headgasket.com/whoweare.html

Originally Posted by techinspector1

I may have an economical fix for you. I ran into these guys several years ago when researching copper head gaskets. They make a very thin compression ring that is affixed to the head gasket and does the same job as an o-ring. Click around on this site and read everything, then call them and discuss making a gasket for your application......
http://www.headgasket.com/whoweare.html

wow, that might be a solution for the Ford 6cyl too. I know I'm gonna pop stock head gaskets if I turn the boost up w/ my Turbo 200 ( if I ever get it running )

I bumped into this thread by accident and curiosity. Back in the old days we used the Isky tool, sure it was expensive back then too but solved the problem. We ran both 392 and 426 hemi on nitro in TF, TFC and alcohol as well as built some motors for boats.

We just o-ringed the block and not the heads. We used copper head gaskets and spay contact cement. 3M stuff. It worked pretty well. It was a real problem to get the heads off if they were on for any length of time but the blown cars had the heads off nearly every week anyway. We also used a bit of silicone sealer around the water holes on those that used water with good success.

I don't remember the exact number but the depth of the groove was about .004 or so less than the wire. We carefully tapped the wire in with a plastic hammer so as not to flatten it. The fuel cars ran a bit more stick out as I recall. I'd guess around .008-.010 as the wire was sometimes hard to get to stay in.

Originally Posted by terrylittlejohn

do you know if he was using a steel or composite head gasket?

Terry (or any other Slant Six guy for that matter) -

Would you happen to know whether the stainless head gaskets like Chrysler used to sell over the counter are available anywhere?

To tell you the truth I have not looked for one yet but if you can save me some time (and maybe some $3.50 a gallon gas) I will appreciate it.

Thanks,

Jim

the stock steel gaskets are out there but hard to find , a fellow slanter sold me two he had but i could not find any in canada, go to the slantsix web site and ask you might find some help

Thanks, Terry,

I'll look around. I had an extra one that had laid around in my garage for years but it must not have made our last move. Anyway, I don't seem to own it anymore.

Jim