.....Ken, yes the frame rails are pinched 3/4" on each side...

.....Henry, well I guess mine was done backwards? The seat was put in {actually it isn't really officially 'in' yet, just sitting there} after the steering was set up...

.....Brian, I didn't measure mine when I was back in Kansas so I have no measurements. I just know that the wheel wasn't centered on my body. I guess it's no big thing but it just didn't seem 'right'. I also didn't like the height of the wheel so they are going to lower it an inch. But I was told that it couldn't be centered that it was just 'the nature of the beast'.... That if it was moved over it would hit the motor. And when I looked it didn't seem as if there was any room. May be I can have them move the seat over as far as possible towards the drivers door??? Plus the seat padding was raised on the sides so that might have thrown me off.....

THANKS everyone Bill