As Bob and others have said, getting a 32 to fit correctly is a real chore!

If you have to put a lot of pressure on one side of the cowl then something is wrong somewhere else.

I went through this trying to keep the doors closed when going through gutters etc. on my rpu.

I would loosen all the body mounts and go get a handful of different thickness front end alignment shims and start shimming under body mounts until everything lines up and doors shut properly. So-Cal speed shop says they start at the rear of the body and work to the front, but I was all over the place adding and subtracting shims til everything worked.
Remember adding shimms to right rear will bring down the left front etc.

Have fun! Its a real pain, but worth it when everything lines up.

I even had to drill and make new rear body mounts as the stock mounts didn't line up with the roadster pickup body.

Hope you made some sense of all this!!

Mick