I did shim at the back of the cowl and it did help with the door alignment. I can't install the spring on the front bolt because I didn't weld the threaded sleeve in at an angle to match the original frame indent. I think I can correct this when I remove the body. I found that the headlight bar would not bolt through the existing fender holes. I have welded these up and have redrilled new ones. I will have to make something that will put the indent back in the fender. I can then modify the fender braces. Everyone was right. This has become such a time consuming project. Without your help, I would have thrown up my hands and given up on this thing. Thanks to all for the help and encouragement!