Thanks for the invitation Rockn Rods! I didn't get your message before I left, so didn't stop in Wylie. Will do so next trip. I did look at a stretched 32 chassis from Pete & Jakes at the Sache Rod Shop. It had been stretched 5" for a sbc blower motor. Nice work. The rear end c-notch was the normal radius at the front, then tapered back at an angle for about 6". I have never seen this before. If anyone is in the Sachse area, they should stop by and look at the 32 extended cab pickup with the dual wheel rear end setup that is in the shop now. The cab bodywork is immaculate, as is the rest!
I am going to look at the Speedway Motors sway bar setup. This sounds more like what I had in mind. I am still not sure what to run for a brake setup. The standard non power pedal looks more original. The power brake pedal is so short, it looks too close to the floor. I am going to fabricate my own pedal pivot bracket, and am looking for location dimensons. If anyone can help out with this, I would appreciate hearing from them. Thanks