Hey folks! So I've been working on this project almost a year. Long story short I built a jeep from scratch ... last week I did all the electrical work and installed my starter.

I got the push start diagram from this forum ... it's time for me to start it. I press the button and the engine turns .. but no gas is getting to my carburetor.

I was told to put some gas in the carb ... can someone guide me through this process ... safely. I'm a little nervous and don't want to do anything to ruin anything. All my gas line, pumps (two one at engine block one in gas tank), fuel filters etc.

How do I get it to turn over by manually bringing the gas to the carb.

BTW engine is a '78 out of a Camaro REBUILT

Thanks in advance ...

Rookie17