I have a 23 T Bucket with a 327. Im wanting to rebuild the motor. It was my fathers car and I really don't know anything about the motor. I do know its a 68 327 with points, double hump heads and 3 deuces. The carbs are Demons 98's. I would like to go thru the motor completely. I would also like to keep the 3 deuces. Im looking for some input on a good build. Would like to get 400 or better out of it. Should I replace the complete rotating assembly? Aluminum heads? I do plan on getting the block cleaned, zero decked and aligned bored. If I keep the crank I will also polished and campher it. I have been reading and there is a lot of opinions, builds, etc. Just looking for input from HotRod guys. After all its going in a 1600# car. I will be running a turbo 350 tranny and it has a 9" rear(don't know gear ratio).
Thanks